It appears that your cart is currently empty
FREE SHIPPING ON ORDERS ABOVE $100!
FiiO Media Player FX1221 SLIVER REFURB X1 2ndGen Portable High-Res Lossless MusicPlayer Retail
Comprehensive improvement of hand feel starting from the touch wheel
By studying and comparing dozens of designs and through hundreds of experiments and tests, we have finally developed the unique FiiO touch wheel with higher sensitivity, better anti-interference, enhanced reliability and longer service life.
Wireless Bluetooth 4.0 allowing to enjoy music easily
The Bluetooth 4.0 system based on F1C81 chip set allows you to easily enjoy the music with reduced latency and high sound quality.
Getting rid of the wire to achieve two functions
Two-way transmission allows it to receive Bluetooth signal while sending Bluetooth signal.
(RM1 can be used at the same time when Bluetooth headphone or Bluetooth speaker is on.)
Not limited by wire
Being not restricted during exercise, you may have a good sweat while enjoying wireless music.
On-board music accompanying you on the way
In-vehicle mode provides a perfect link between music and vehicle audio system, which has greatly improved the acoustic quality of vehicle audio system and let you enjoy music on the way.
(When vehicle engine is ignited, X1 is turned on too. When you shut down the engine, X1 stops immediately. There are no tedious manual operations anymore.)
Dedicated professional high quality DAC chip
Utilizing Texas Instruments high quality CM5242, the all new X1 gets higher signal-to-noise ratio and supports full differential line output to achieve balanced line output function, as compared with PCM5142 of last generation.
Further optimized architecture
With dedicated LPF and operational amplifier, we have optimized design of power architecture and circuit at the same time to further improve sound quality of the all new X1, making better low-frequency and depth.
General Specifications
Color Available
Sliver
Display Screen
TFT 320x240
Analog Audio Output Jack(LO)
3.5 mm headphone output jack
Digital Audio Output Jack
N/A
USB DAC
N/A
Chips used
SoC: JZ4760B, DAC: PCM5242, LPF: OPA2322, OP: ISL28291
Headphone out (PO)
3.5mm headphone output jack
Headphone Impedance Range
16-100 ohm
Volume control type
100 steps digital potentiometer
Bass Boost
N/A
Treble
N/A
Balance
5 dB
Gain Selection
N/A
Equalizer
7-band equalizer (+/-6dB)
Partial Performance Parameters for Line Output
THD+N
less than or equal 0.003% (1 kHz)
Frequency Response
5 Hz-60 kHz (-3dB)
Crosstalk
more than or equal 101 dB (10 K ohm/1 kHz)
SNR
more than or equal 115 dB (A-weighted)
By studying and comparing dozens of designs and through hundreds of experiments and tests, we have finally developed the unique FiiO touch wheel with higher sensitivity, better anti-interference, enhanced reliability and longer service life.
Wireless Bluetooth 4.0 allowing to enjoy music easily
The Bluetooth 4.0 system based on F1C81 chip set allows you to easily enjoy the music with reduced latency and high sound quality.
Getting rid of the wire to achieve two functions
Two-way transmission allows it to receive Bluetooth signal while sending Bluetooth signal.
(RM1 can be used at the same time when Bluetooth headphone or Bluetooth speaker is on.)
Not limited by wire
Being not restricted during exercise, you may have a good sweat while enjoying wireless music.
On-board music accompanying you on the way
In-vehicle mode provides a perfect link between music and vehicle audio system, which has greatly improved the acoustic quality of vehicle audio system and let you enjoy music on the way.
(When vehicle engine is ignited, X1 is turned on too. When you shut down the engine, X1 stops immediately. There are no tedious manual operations anymore.)
Dedicated professional high quality DAC chip
Utilizing Texas Instruments high quality CM5242, the all new X1 gets higher signal-to-noise ratio and supports full differential line output to achieve balanced line output function, as compared with PCM5142 of last generation.
Further optimized architecture
With dedicated LPF and operational amplifier, we have optimized design of power architecture and circuit at the same time to further improve sound quality of the all new X1, making better low-frequency and depth.
General Specifications
Color Available
Sliver
Display Screen
TFT 320x240
Analog Audio Output Jack(LO)
3.5 mm headphone output jack
Digital Audio Output Jack
N/A
USB DAC
N/A
Chips used
SoC: JZ4760B, DAC: PCM5242, LPF: OPA2322, OP: ISL28291
Headphone out (PO)
3.5mm headphone output jack
Headphone Impedance Range
16-100 ohm
Volume control type
100 steps digital potentiometer
Bass Boost
N/A
Treble
N/A
Balance
5 dB
Gain Selection
N/A
Equalizer
7-band equalizer (+/-6dB)
Partial Performance Parameters for Line Output
THD+N
less than or equal 0.003% (1 kHz)
Frequency Response
5 Hz-60 kHz (-3dB)
Crosstalk
more than or equal 101 dB (10 K ohm/1 kHz)
SNR
more than or equal 115 dB (A-weighted)
Shipping
Orders below $100: $10 flat rate
Orders above $100: FREE
Currently we only ship within the US.
Returns
You have 14 calendar days to return an item from the date you received it.
To be eligible for a return, your item must be unopened in the same condition that you received it.
Your item must be in the original packaging.
Your item needs to have the receipt or proof of purchase.
Refunds
Once we receive your item, we will inspect it and notify you that we have received your returned
item. We will immediately notify you on the status of your refund after inspecting the item.
If your return is approved, we will initiate a refund to your credit card (or original method of payment).
You will receive the credit within a certain amount of days, depending on your card issuer's policies.
Shipping
You will be responsible for paying for your own shipping costs for returning your item. Shipping costs are nonrefundable.
If you receive a refund, the cost of return shipping will be deducted from your refund.
Contact Us
If you have any questions on how to return your item to us, contact us.